Ok im designing a PCB and going through some info i found this line:
DEBUG_N to pin 11 of the xSYS header
on page 47 of the datasheet... there is no such pin on the device...
Now what? Just leave it NC?
DEBUG_N ??
-
AtomSoft
- XCore Addict
- Posts: 135
- Joined: Mon Dec 14, 2009 3:02 pm
-
AtomSoft
- XCore Addict
- Posts: 135
- Joined: Mon Dec 14, 2009 3:02 pm
Also while on the subject of the datasheet and the xSYS connector...
Is pin 1 5v in from XTAG? or should i connect 5v from my project?
Is pin 1 5v in from XTAG? or should i connect 5v from my project?
-
segher
- XCore Expert
- Posts: 844
- Joined: Sun Jul 11, 2010 1:31 am
Yes, you can leave DEBUG_N unconnected.
-
AtomSoft
- XCore Addict
- Posts: 135
- Joined: Mon Dec 14, 2009 3:02 pm
Thanks!