Hi,
Can we install a new hardware from a user .xn file from the command line, instead of xTIMEComposer "Help>Install New Hardware" utility?
Thanks.
xTIMEComposer command line - Installing a new hardware
-
- Junior Member
- Posts: 5
- Joined: Tue Jul 04, 2017 7:56 pm
-
- Active Member
- Posts: 62
- Joined: Wed Feb 17, 2016 5:10 pm
If your .xn file is in the project directory, you should just be able to specify it in your Makefile and then run xmake.
Add a line in your Makefile like this:
TARGET = my_hardware
If your xn file is called my_hardware.xn
Add a line in your Makefile like this:
TARGET = my_hardware
If your xn file is called my_hardware.xn
-
- Junior Member
- Posts: 5
- Joined: Tue Jul 04, 2017 7:56 pm
Thank you for your reply. Probably the initial error I have seen was about dangling project directory links. It works now.