Hi,
Did any one configured the XCORE 200 with 100MbPS Realtime as mentioned in documentation.
I am facing issues to send and receive packets. I try to debug and notice that the mii_rx_thread andmii_tx_thread are not running.
Can anyone help me in getting further.
Thanks
Lokesh
XCORE 200 with 100MbPS Realtime
-
- Member++
- Posts: 29
- Joined: Wed Feb 06, 2013 2:24 pm
-
- Respected Member
- Posts: 275
- Joined: Fri Mar 12, 2010 6:03 pm
What sort of issues are you facing?
-
- Member++
- Posts: 29
- Joined: Wed Feb 06, 2013 2:24 pm
Hi,
I am have configured the board as xmos talker and try to stream avb frames.
But i noticed that the streams are initialized and but no frames are send out on ethernet.
No ptp or avb messages are available on network.
When i run the step by step to find issue,
I have made the same code from documentation and the smi initialization was same as RGMII with 100mbps configuration.
Addtional Info: The TXCLK turns off after startup of the system.
Can you please help me in finding the issue
Thanks
Lokesh
I am have configured the board as xmos talker and try to stream avb frames.
But i noticed that the streams are initialized and but no frames are send out on ethernet.
No ptp or avb messages are available on network.
When i run the step by step to find issue,
- in function mii_ethernet_server(), in case send_buffer fro high priority tx the buffer is created and packet length is available there, the next steps mii commit and mii_add_packet is also completed but on mii_master_tx_pins (in mii_master.xc) side the thread stops communicating or keeping data on pins. This works fine only for one packet but then stops any further.
I have made the same code from documentation and the smi initialization was same as RGMII with 100mbps configuration.
Addtional Info: The TXCLK turns off after startup of the system.
Can you please help me in finding the issue
Thanks
Lokesh
-
- Member++
- Posts: 29
- Joined: Wed Feb 06, 2013 2:24 pm
Is the SMI configuration is same ar RGMII except changing speed to 100mbps. Should I need to take care anyother things init.
I try to monitor the speed after smi configuration which is 100mbps.
I try to monitor the speed after smi configuration which is 100mbps.