xrun: Cannot load image, XCore 0 is not enabled

Sub forums for various specialist XMOS applications. e.g. USB audio, motor control and robotics.
User avatar
xlordofpainx
Experienced Member
Posts: 78
Joined: Thu Mar 08, 2018 2:44 pm

Post by xlordofpainx »

I am using usb in and 2 spdif ins. And while i can power it with USB i am using just 2 poles and an external power supply for the 5V


User avatar
xlordofpainx
Experienced Member
Posts: 78
Joined: Thu Mar 08, 2018 2:44 pm

Post by xlordofpainx »

New fresh error - Error on tile[0]: failed to connect to flash device. Please verify that SQI type is supported and that the correct SQI ports are defined within your xn file. Looking into it i did find similar posts and I am using the default codes, but I don't know how to proceed with adapting to my situation.


xflash: Error: F03096 Node "0" is configured to boot from a device but no suitable device was found.
This posts when i try flashing a new Hello world onto it
User avatar
mon2
XCore Legend
Posts: 1913
Joined: Thu Jun 10, 2010 11:43 am
Contact:

Post by mon2 »

Post full part number and vendor of the flash being used.
User avatar
xlordofpainx
Experienced Member
Posts: 78
Joined: Thu Mar 08, 2018 2:44 pm

Post by xlordofpainx »

SST26VF016-80-5I-S2AE FLASH MEMORY, 16MBIT, 80MHZ, SOIC-8 85423275 Manufacturer code - SST26VF016-80-5I-S2AE -- -Bought from Farnell
User avatar
xlordofpainx
Experienced Member
Posts: 78
Joined: Thu Mar 08, 2018 2:44 pm

Post by xlordofpainx »

I used an osciloscope to monitor what happens to the pins during flash and a spike is always present when it tries to flash so connection is out of the way i guesss
Post Reply