Hello everyone !
I'm discovering XMOS because I have to make a 5.1 audio file player for a project. I'm searching for informations about possibilities I can have with my hardware.
I just have to do a mass storage and an audio file playing (mono or stereo to begin ^^). I have a SliceKit and a SK-Audio slice card. Do anyone have a little answer to my question ? To begin I just want to know if I have the sufficient hardware to make what I want to do ^^
Thanks !
Play audio file with SliceKit and XA-SK-AUDIO
Hi pierreko,
You don't say which SliceKit you have, however, if you are thinking about USB audio then the best solution is the xCORE-200 multi channel board :
https://www.xmos.com/support/boards?product=18334
And the USB audio firmware which you can download from the same page.
Best regards,
John
You don't say which SliceKit you have, however, if you are thinking about USB audio then the best solution is the xCORE-200 multi channel board :
https://www.xmos.com/support/boards?product=18334
And the USB audio firmware which you can download from the same page.
Best regards,
John
Hello !
In fact I have the audio slice card : https://www.xmos.com/support/boards?product=15827,
- sliceKit XS1 : https://www.xmos.com/support/boards?product=17554
- sliceKit Core : https://www.xmos.com/support/boards?product=15826
- and USB sliceKit : https://www.xmos.com/support/boards?product=17036
thanks !
In fact I have the audio slice card : https://www.xmos.com/support/boards?product=15827,
- sliceKit XS1 : https://www.xmos.com/support/boards?product=17554
- sliceKit Core : https://www.xmos.com/support/boards?product=15826
- and USB sliceKit : https://www.xmos.com/support/boards?product=17036
thanks !
Hi pierreko ,
These slicekits are all based around the old XS1 architecture, which is not recommended for new designs.
I would still suggest the xCORE-200 multi channel card.
Best regards,
John
These slicekits are all based around the old XS1 architecture, which is not recommended for new designs.
I would still suggest the xCORE-200 multi channel card.
Best regards,
John
Okay I understand but do you think it is possible to begin ?
By all means.
If you download the USB audio f/w from the muli-channel page and build app_usb_aud_skc_u16. It will run on the USB slicekit and your audio card.
John
If you download the USB audio f/w from the muli-channel page and build app_usb_aud_skc_u16. It will run on the USB slicekit and your audio card.
John