I want to store some data in the Flash. In the manual it says the default boot partition is the entire boot partition is 0 bytes. How do I specify / allocate some space on the data partition? I looked through the documentation but could not find it. I would assume it should be an Xflash command when writing the initial flash to the device.
Also I've been using the OTP with the AES loader. The AES loader is created and burned into OTP but I can't modify it since there is no source. Is this available or is there a way to store additional information into the OTP (serial number/mac address) and read it back out?
Often times I want to serialize the device and issue firmware updates to my customers but do not want the firmware update to overwrite the serialized data. It's best if I could write this into OTP and read out parts of the OTP but as a current workaround I can settle for writing into the data partition of the flash which wouldn't be erased with a firmware update.
x-flash and data partition + OTP programming
try xflash with the following option:kster59 wrote:I want to store some data in the Flash. In the manual it says the default boot partition is the entire boot partition is 0 bytes. How do I specify / allocate some space on the data partition? I looked through the documentation but could not find it. I would assume it should be an Xflash command when writing the initial flash to the device.
The remaining space will be the data partition.--boot-partition-size <n>
Specify the size of the boot partition as <n> bytes
-
- Member
- Posts: 15
- Joined: Mon May 28, 2012 11:20 am
In the command window, I typed
xflash -target=XK-1A --boot-partition-size 120000
I am getting a message, "ERROR: F03021 No input archive specified
xflash -target=XK-1A --boot-partition-size 120000
I am getting a message, "ERROR: F03021 No input archive specified
You need to specify the XE file in order for xflash to know what to flash :)shyamkrish8iitm wrote:In the command window, I typed
xflash -target=XK-1A --boot-partition-size 120000
I am getting a message, "ERROR: F03021 No input archive specified
- JohnWilson
- Active Member
- Posts: 38
- Joined: Fri Oct 28, 2011 10:53 pm
- Contact:
Just out of curiosity, is there a way to do this in the IDE settings or do you have to do the xflash command by hand to have a data partition?
Yes there is a flash configurations menu which allows you to input these settings and flash the device.JohnWilson wrote:Just out of curiosity, is there a way to do this in the IDE settings or do you have to do the xflash command by hand to have a data partition?
- JohnWilson
- Active Member
- Posts: 38
- Joined: Fri Oct 28, 2011 10:53 pm
- Contact:
No idea why I had trouble finding that before. Beautiful -- thanks!!!