Is the following document is the one you are looking for: https://www.xmos.com/download/public/sl ... l(1.0).pdf
Section 4.3.
Where can I get the full specification for a sliceCard edge Topic is solved
-
- New User
- Posts: 2
- Joined: Fri May 23, 2014 7:10 pm
-
- XCore Expert
- Posts: 589
- Joined: Wed Feb 29, 2012 10:03 am
-
- Member++
- Posts: 17
- Joined: Tue Mar 19, 2013 11:58 am
The datasheet for the connector and corresponding finger spec can be found here http://www.sullinscorp.com/drawings/44_ ... 1042-E.pdf the part used on the slicekit is NWE18DHRQ-T941.
The position of the retaining hole is not fixed, it can be moved for ease of routing, it just needs to be clear of the connector body when mated, 9mm back from the board edge in line with the mechanical key is a good starting point.
The position of the retaining hole is not fixed, it can be moved for ease of routing, it just needs to be clear of the connector body when mated, 9mm back from the board edge in line with the mechanical key is a good starting point.