What is the proper way to connect the LCD to the LCD slice
-
- New User
- Posts: 2
- Joined: Fri May 23, 2014 7:10 pm
What is the proper way to connect the LCD to the LCD slice
The LCD Demo Quickstart Guide shows a picture of the hardware setup for the LCD Demo. In this photo, Pin 1 of the LCD flex is connected to Pin 40 on the slice connector and Pin 40 on the LCD flex is connected to pin 1 on the slice connector. Is this correct? Is there an error in the labeling?Also, are there any suggestion for how to mate the LCD flex cable to the slice connector. It doesn't seem to slide in very easily. Does the connector open in some way?
-
- XCore Expert
- Posts: 754
- Joined: Thu Dec 10, 2009 6:56 pm
I don't have a LCD slice but I try to answer your question.There is a lever (black thingie) on the connector that you have to carefully move (horizontal i guess), then the flex cable should move in fairly easily. After that you have to move the lever back.This image might help you to find the right orientation of the flex cable:https://www.xmos.com/files/images/15954 ... _setup.jpg