Hi,
Constraints check gives the following warning:
xmap: Warning: port "XS1_PORT_1B" on tile[1] is not connected to any pins in this package.
xmap: Warning: port "XS1_PORT_1A" on tile[1] is not connected to any pins in this package.
The XEF232-1024-FB374 Datasheet - p. 23 says that this pins are connected.
This is the RGMII_PORTS_INITIALIZER from the reference design, whioch should work for the XEF232-1024-FB374 too:
#define RGMII_PORTS_INITIALIZER { \
XS1_PORT_1O, \
XS1_PORT_1A, \
XS1_PORT_8A, \
XS1_PORT_4E, \
XS1_PORT_4F, \
XS1_PORT_1B, \
XS1_PORT_1K, \
XS1_PORT_1P, \
XS1_PORT_1G, \
XS1_PORT_1E, \
XS1_PORT_1F, \
XS1_PORT_8B, \
XS1_CLKBLK_1, \
XS1_CLKBLK_2, \
XS1_CLKBLK_3, \
XS1_CLKBLK_4 \
}
Any help is appreciated.
Thanks!
Warning: port "XS1_PORT_1B" on tile[1] is not connected... Topic is solved
-
- Member
- Posts: 15
- Joined: Tue Sep 24, 2013 1:07 pm
-
- Member++
- Posts: 22
- Joined: Thu Apr 10, 2014 9:39 am
Hello,
These pins are not bonded out the external package pins, but are used internally to connect to the RGMII block.
Rob
These pins are not bonded out the external package pins, but are used internally to connect to the RGMII block.
Rob
-
- Member
- Posts: 15
- Joined: Tue Sep 24, 2013 1:07 pm
It was the "RGMII Tx Timing"-Bit that had to be configured properly. Confusing datasheet...
I tried to change the "RGMII Rx Timing"-Bit before. With no effect of course.
I tried to change the "RGMII Rx Timing"-Bit before. With no effect of course.