Hi,
I recently got a xCore Microphone Array board and trying to flash the firmware (AN00217: High Resolution Delay Example) .
When I try to flash the firmware, i get the below error :
Error: F03096 No devices attached - Cannot run the enquirer until a device is found
Can please someone tell me what is wrong and how to proceed?
Regards!
Error: F03096 No devices attached - Cannot run the enquirer until a device is found
-
- Junior Member
- Posts: 4
- Joined: Wed Feb 15, 2017 1:24 pm
-
- XCore Legend
- Posts: 1913
- Joined: Thu Jun 10, 2010 11:43 am
-
- Junior Member
- Posts: 4
- Joined: Wed Feb 15, 2017 1:24 pm
Hi,
Thanks for your quick reply. However, I tried your suggestion and still doesn't recognize the XTAG3 on Windows.
As a workaround, I tried the same example on my Ubuntu machine and I am successfull in flashing the firmware. But, my question is Do I need to change any settings so the device is recognized as a USB microphone array in Audacity?
Regards!
-
- XCore Addict
- Posts: 185
- Joined: Tue Mar 26, 2013 12:10 pm
Hi,
Can you check to see if you are connecting to a USB 2 port or USB 3 (USB 3 are usually blue connectors internally).
Thanks very much,
john
Can you check to see if you are connecting to a USB 2 port or USB 3 (USB 3 are usually blue connectors internally).
Thanks very much,
john
-
- XCore Addict
- Posts: 185
- Joined: Tue Mar 26, 2013 12:10 pm
Oh one other option would be to use Nirsoft USB Dev View to remove all instances of the driver. Then disconnect and reconnect the xtag.
You can sort on VID - the XMOS VID it 20B1.
Best regards,
John
You can sort on VID - the XMOS VID it 20B1.
Best regards,
John
-
- Junior Member
- Posts: 4
- Joined: Wed Feb 15, 2017 1:24 pm
HI @johned,
On Windows PC, I am using USB3
On Windows PC, I am using USB3
-
- XCore Addict
- Posts: 185
- Joined: Tue Mar 26, 2013 12:10 pm
Please could you try a USB 2 port ?
Best,
John
Best,
John