Error: F03096 No devices attached - Cannot run the enquirer until a device is found

New to XMOS and XCore? Get started here.
Post Reply
phani.s
Junior Member
Posts: 4
Joined: Wed Feb 15, 2017 1:24 pm

Error: F03096 No devices attached - Cannot run the enquirer until a device is found

Post by phani.s »

Hi,

I recently got a xCore Microphone Array board and trying to flash the firmware (AN00217: High Resolution Delay Example) .
When I try to flash the firmware, i get the below error :

Error: F03096 No devices attached - Cannot run the enquirer until a device is found

Can please someone tell me what is wrong and how to proceed?

Regards!


phani.s
Junior Member
Posts: 4
Joined: Wed Feb 15, 2017 1:24 pm

Post by phani.s »

Hi,

Thanks for your quick reply. However, I tried your suggestion and still doesn't recognize the XTAG3 on Windows.
As a workaround, I tried the same example on my Ubuntu machine and I am successfull in flashing the firmware. But, my question is Do I need to change any settings so the device is recognized as a USB microphone array in Audacity?

Regards!
User avatar
johned
XCore Addict
Posts: 185
Joined: Tue Mar 26, 2013 12:10 pm
Contact:

Post by johned »

Hi,
Can you check to see if you are connecting to a USB 2 port or USB 3 (USB 3 are usually blue connectors internally).
Thanks very much,
john
User avatar
johned
XCore Addict
Posts: 185
Joined: Tue Mar 26, 2013 12:10 pm
Contact:

Post by johned »

Oh one other option would be to use Nirsoft USB Dev View to remove all instances of the driver. Then disconnect and reconnect the xtag.
You can sort on VID - the XMOS VID it 20B1.
Best regards,
John
phani.s
Junior Member
Posts: 4
Joined: Wed Feb 15, 2017 1:24 pm

Post by phani.s »

HI @johned,

On Windows PC, I am using USB3
User avatar
johned
XCore Addict
Posts: 185
Joined: Tue Mar 26, 2013 12:10 pm
Contact:

Post by johned »

Please could you try a USB 2 port ?

Best,
John
Post Reply