On a L2-Slice-Kit board, I managed to get the AN00122 (webserver) demo running. The port definition is correct for the CIRCLE slot. However, I would like to use the SQUARE slot and adapted the port configuration as much as I could but never succeeded.
Based on an older (back in 2010) post somebody referred to
Code: Select all
#define SMI_COMBINE_MDC_MDIO 1
#define SMI_MDC_BIT 0
#define SMI_MDIO_BIT 1
#define ETHERNET_DEFAULT_TILE tile[1]
#define PORT_ETH_RXCLK on tile[1]: XS1_PORT_1B
#define PORT_ETH_RXD on tile[1]: XS1_PORT_4A
#define PORT_ETH_TXD on tile[1]: XS1_PORT_4B
#define PORT_ETH_RXDV on tile[1]: XS1_PORT_1C
#define PORT_ETH_TXEN on tile[1]: XS1_PORT_1F
#define PORT_ETH_TXCLK on tile[1]: XS1_PORT_1G
#define PORT_ETH_MDIOC on tile[1]: XS1_PORT_4C
#define PORT_ETH_MDIOFAKE on tile[1]: XS1_PORT_8A
#define PORT_ETH_ERR on tile[1]: XS1_PORT_4D
Code: Select all
#define SMI_COMBINE_MDC_MDIO 1
#define SMI_MDC_BIT 0
#define SMI_MDIO_BIT 1
As of now, I have:
Code: Select all
#define ETHERNET_USE_SQUARE_SLOT
port p_eth_rxclk = on tile[1]: XS1_PORT_1B; //XS1_PORT_1J on CIRCLE
port p_eth_rxd = on tile[1]: XS1_PORT_4A; //XS1_PORT_4E on CIRCLE
port p_eth_txd = on tile[1]: XS1_PORT_4B; //XS1_PORT_4F on CIRCLE
port p_eth_rxdv = on tile[1]: XS1_PORT_1C; //XS1_PORT_1 on CIRCLE
port p_eth_txen = on tile[1]: XS1_PORT_1F; //XS1_PORT_1L on CIRCLE
port p_eth_txclk = on tile[1]: XS1_PORT_1G; //XS1_PORT_1I on CIRCLE
port p_eth_rxerr = on tile[1]: XS1_PORT_4D; //(bit1) //XS1_PORT_1P on CIRCLE
port p_eth_timing = on tile[1]: XS1_PORT_8C; //CIRCLE good, SQUARE?
clock eth_rxclk = on tile[1]: XS1_CLKBLK_1;
clock eth_txclk = on tile[1]: XS1_CLKBLK_2;
port p_smi_mdio = on tile[1]: XS1_PORT_8A; // (bit0) //XS1_PORT_1M on CIRCLE
port p_smi_mdc = on tile[1]: XS1_PORT_4C; // (bit1) //XS1_PORT_1N on CIRCLE
So how are those ports supposed to be when I must use the SQUARE port?
Any help would be very much appreciated?
Thanks!