I've only have had a quick glance at the power board because i currently don't have much time.
A few things that i want to point out:
- Your power traces are still very thin, they should be at least 2-4 times wider, equal to the pad width or slightly smaller/larger.
- Design for manufacturability: don't lay traces very close to other components if there is plenty of space. I see a few traces that are unnecessarily close to component pads.
- Some funny 90 degree corners just right off the component pads that can be avoided.
- Lay decoupling capacitors for the regulators as close as possible to the regulators, some improvement is possible.
Mad Scientist Audio Interface
-
- XCore Expert
- Posts: 754
- Joined: Thu Dec 10, 2009 6:56 pm
-
- Member
- Posts: 14
- Joined: Sat Nov 10, 2012 6:08 am
http://www.mouser.com/ProductDetail/Pan ... 1cpRDLz5lw
@Ale - Are these sufficient in your opinion? I know they are quite large but the way I was planning on Stacking the boards in the enclosure I should have more than sufficient room.
@Ale - Are these sufficient in your opinion? I know they are quite large but the way I was planning on Stacking the boards in the enclosure I should have more than sufficient room.