Hello,
the gpio slicecard has two jumpers (p3 and p5), a header of pins (p1) and empty pin headers (p4 and p2). Can someone please explain how they are connected to the signals of a slot?. I would like to use them, but don't know exactly to what signals they are connected to.
Thanks
Derick
Which signals on GPIO sliceCARD extra headers are connected
-
- New User
- Posts: 2
- Joined: Sun Jun 09, 2013 12:55 pm
-
- XCore Expert
- Posts: 589
- Joined: Wed Feb 29, 2012 10:03 am
The signals in the PCIE_36_FINGER connector are brought on to the headers P2 and P4 to make them available if you want to use these pins for some other purpose.
GPIO Slice hardware manual is available in the following link :
https://www.xmos.com/download/public/XA ... wguide.pdf
GPIO sliceCARD schematics and design files are available in the following link:
https://www.xmos.com/support/downloads/ ... duct=15831
GPIO Slice hardware manual is available in the following link :
https://www.xmos.com/download/public/XA ... wguide.pdf
GPIO sliceCARD schematics and design files are available in the following link:
https://www.xmos.com/support/downloads/ ... duct=15831
-
- XCore Legend
- Posts: 1913
- Joined: Thu Jun 10, 2010 11:43 am
Be sure to view this post as well on topic:
http://www.xcore.com/forum/viewtopic.ph ... 909#p13909
Hope it helps. Can someone @ XMOS review / acknowledge / correct this bug report from Dec. 2012 ?
Thanks.
Kumar
http://www.xcore.com/forum/viewtopic.ph ... 909#p13909
Hope it helps. Can someone @ XMOS review / acknowledge / correct this bug report from Dec. 2012 ?
Thanks.
Kumar