XE232 USB & XTAG
Posted: Wed Aug 23, 2017 7:50 pm
XMOS processor: XE232-1024
Migrating from XS1-G04B to XE232 processor.
USB
Q1) What is the correct hardware configuration of the un-used USB ports?
Reviewed available documentation but cannot locate how to configure the unused USB port connections.
The XE232 data sheet reference to "how to connect those USB ports are documented in an application note on USB for xCORE-200." leads to software centric app. notes.
xTAG Debug Connector
The XS-2 Evaluation Board ,with XS1-G04B, XTAG connector pin-out is different than what is identified on the XE216 evaluation boards and in the XE232 data sheet.
Referencing XE232 data sheet Section G.2 & G3. for full xSYS header.
Q2) Has there been a change to the xTAG debug connector pin out from the XS1-G04B to the XE232 processors?
Q3 UART connections of the XS-2 Eval. Bd. are missing from the XE216 Evaluation boards and XE232 data sheet is that correct?
Q4) Is the xTAG Pin3 TRST_N (MSEL) "Select boot from JTAG" signal not required for the XE2xx series?
Q5) Are there multiple versions of the XTAG debug board or just one for all Evaluation Boards?
Migrating from XS1-G04B to XE232 processor.
USB
Q1) What is the correct hardware configuration of the un-used USB ports?
Reviewed available documentation but cannot locate how to configure the unused USB port connections.
The XE232 data sheet reference to "how to connect those USB ports are documented in an application note on USB for xCORE-200." leads to software centric app. notes.
xTAG Debug Connector
The XS-2 Evaluation Board ,with XS1-G04B, XTAG connector pin-out is different than what is identified on the XE216 evaluation boards and in the XE232 data sheet.
Referencing XE232 data sheet Section G.2 & G3. for full xSYS header.
Q2) Has there been a change to the xTAG debug connector pin out from the XS1-G04B to the XE232 processors?
Q3 UART connections of the XS-2 Eval. Bd. are missing from the XE216 Evaluation boards and XE232 data sheet is that correct?
Q4) Is the xTAG Pin3 TRST_N (MSEL) "Select boot from JTAG" signal not required for the XE2xx series?
Q5) Are there multiple versions of the XTAG debug board or just one for all Evaluation Boards?