Why do I have to rebuild my project before flashing?
Why do I have to rebuild my project before flashing?
Strangely, I always need to Clean my build before flashing my program into my XK-1A. Otherwise, the program won't be flashed into my XK-1A even though it's written in the console that the flashing succeeded.
Hi Mifay,
I just had a go at reproducing this one. Using the XDE, a XK-1A, and a program that blinks an led, I'm able to compile, flash, then run from flash without performing any cleaning. What board are you using? Also, are you able to send me a project that exhibits this behaviour?
I just had a go at reproducing this one. Using the XDE, a XK-1A, and a program that blinks an led, I'm able to compile, flash, then run from flash without performing any cleaning. What board are you using? Also, are you able to send me a project that exhibits this behaviour?