Hello All,
I've completed the second version of the XMOS dip but had a quick question. Although I have a pretty good understanding of the hardware requirements of the XMOS I'm still trying to grasp the programming environment. So I understand that the FLASH chip can be picked using the XN file but if I wanted to use a flash chip that had different memory size or speed, how would I go about interfacing with it? Do I just change some things in the XN file?
Using a different Flash module
To use a flash device that is not supported by XMOS you will have to write a flash device description file.
There are minimal requirements for SPI flash devices such as supporting the "slow read" command, so most flash devices can be used.
See http://www.xmos.com/add-support-new-fla ... ?support=1 for writing your own flash device description file.
There are minimal requirements for SPI flash devices such as supporting the "slow read" command, so most flash devices can be used.
See http://www.xmos.com/add-support-new-fla ... ?support=1 for writing your own flash device description file.