I've had some time to ponder the XC-1A kit and have a few questions:
It appears the chips are all 3.3V, and yet some of the breakout pins on the XC-1A seem to be labelled 5v - I take it these should never be connected to any of the io lines from the chip?
I found the L1 reference schematic, here -
https://www.xmos.com/support/silicon
Is this still a valid - and is there a kit of parts available anywhere?
L1 XCore 101
-
shobley
- Junior Member
- Posts: 5
- Joined: Thu Feb 17, 2011 11:32 pm
-
lilltroll
- XCore Expert
- Posts: 956
- Joined: Fri Dec 11, 2009 3:53 am
- Location: Sweden, Eskilstuna
The G series of chip, tolerates 5V input on the I/O pins.
The L -series does not tolerate 5V.
The XC cards are based on G-serie.
The XK cards are based on L-serie.
The L -series does not tolerate 5V.
The XC cards are based on G-serie.
The XK cards are based on L-serie.
Probably not the most confused programmer anymore on the XCORE forum.
-
shobley
- Junior Member
- Posts: 5
- Joined: Thu Feb 17, 2011 11:32 pm
Thanks!
I was looking for an L1 footprint in the Sparkfun library, but can't seem to find it - is it still included?
I was looking for an L1 footprint in the Sparkfun library, but can't seem to find it - is it still included?
-
octal
- XCore Addict
- Posts: 228
- Joined: Thu Jan 27, 2011 3:30 pm
- Location: Argenteuil - France