Xcore microphone array board issues
Posted: Tue Aug 16, 2016 10:42 am
Hi all,
I am new to Xcore programming. I am trying to execute an example on the Xcore microphone array board (XK-USB-MIC-UF216) but I am having some issues. When I connect the board to the USB all leds (14) are switched on by default. All of them in red. I do not think this is normal but I have not found any reference to this in the documentation. When I try to run the compiled code (run-run configuration) , in the target list it shows XMOS XTAG-3 connected to O[0] [VcVSXw44]. Is this right? Should it show something different? when the code is running the XTAG leds flash but the array board does not do anything written in the code compiled. Could you please help me with this?
In addition, in the makefile, I am using XUF216-512-TQ128-C20 which is the microcontroller included in the board. Is this right?
Many thanks,
Juan
I am new to Xcore programming. I am trying to execute an example on the Xcore microphone array board (XK-USB-MIC-UF216) but I am having some issues. When I connect the board to the USB all leds (14) are switched on by default. All of them in red. I do not think this is normal but I have not found any reference to this in the documentation. When I try to run the compiled code (run-run configuration) , in the target list it shows XMOS XTAG-3 connected to O[0] [VcVSXw44]. Is this right? Should it show something different? when the code is running the XTAG leds flash but the array board does not do anything written in the code compiled. Could you please help me with this?
In addition, in the makefile, I am using XUF216-512-TQ128-C20 which is the microcontroller included in the board. Is this right?
Many thanks,
Juan