Toolchain: 14.1.2
XTAG: XTAG2 rev 1.0
Board: Explorer-kit (xCore-200)
OS: Win7-64 bit
*******************************************
I cannot make any of the xscope examples - like AN10089_xscope_printing work on my Explorer-kit.
If I change the enabled="false" in xSCOPEconfig + choosing JTAG connection, I get the printout over JTAG, but all atemps to use xSCOPE has failed.
xTIMEcomposer has autoselected/loaded the XCORE-200-EXPLORER.xn file by selecting the board in the makefile.
What to do ?
Has anyone else made xSCOPE work on the Explorer board ?
Trouble with xscope (Explorer-Kit & XTAG2 1v0)
-
- XCore Expert
- Posts: 956
- Joined: Fri Dec 11, 2009 3:53 am
- Location: Sweden, Eskilstuna
Trouble with xscope (Explorer-Kit & XTAG2 1v0)
Probably not the most confused programmer anymore on the XCORE forum.
-
- XCore Addict
- Posts: 185
- Joined: Tue Mar 26, 2013 12:10 pm
Hi There,
I use xSCOPE on my explorer board a lot, with no problems.
I do this from the tools by enabling xSCOPE in the run dialog.
Have you checked out our applications notes : https://www.xmos.com/support/appnotes ?
I hope this helps.
Best regards,
John
I use xSCOPE on my explorer board a lot, with no problems.
I do this from the tools by enabling xSCOPE in the run dialog.
Have you checked out our applications notes : https://www.xmos.com/support/appnotes ?
I hope this helps.
Best regards,
John