QSPI Flash programmer/ing

[FDemo]

Hi

I didn't want to create a new topic. Building on the topic what cost effective third-party programmer
does Xmos recommend to program the QSPI ?

As in the datasheet is says LSB first and Quad SPI mode enabled in the status register. I assume the *.bin
is written from address 0x00000 and the Quad SPI mode is a setting in the flash utility?

I could start another topic if required but if I want to change the user Configuration on the fly at 0x80000,
do I just keep the RST_N low while I set the new bytes and release RST_N once I'm done. Or is a full power cycle
required for the chip to reload its code and user configuration.

Thank you.