http://www.analog.com/static/imported-f ... 3_5254.pdf
AD0 and AD1 are grounded, so the device address should be 0b1011000 (can anyone check this?)
I am using the I2C 2.0.0 module, module_i2c_master. Using this doesn't do anything:
Code: Select all
i2c_master_write_reg(0b1011000, 0, data, 1, i2c);
Which looks completely wrong. I realize this might be due to the low sampling rate of the USB logical analyzer, so I am going to try and get a capture off of my 100 Mhz scope (probably be at least 2 Gsps).
Any help would be fantastic!
EDIT: I'm also not quite sure about the WP pin. As I understand it, it should be tied high to enable full R/W access, correct?