how to connect 3 startkit with xconnect , and how to write XN file for this xconnect.
The following is my project schematic.
[startkit board 1] <======linkc =====> [startkit board 2] <=====link D =====> [startkit board 3]
xconnect
-
srinie
- XCore Addict
- Posts: 158
- Joined: Thu Mar 20, 2014 8:04 am
Attached a sample xn file to connect 4 startKITs. Remove the *.txt extension and may be adapted to fewer or more startKITs accordingly.
Useful references:
Useful references:
You do not have the required permissions to view the files attached to this post.
-
srinie
- XCore Addict
- Posts: 158
- Joined: Thu Mar 20, 2014 8:04 am
Hi,
Documents referenced above should be good to write the routing table.
In the xn file attachment, refer to the initial commented section for the routing info used in that xn.
An application example for this is a good suggestion, and hopefully we can see one coming up in the shorter run.
regards,
/srinie
Documents referenced above should be good to write the routing table.
In the xn file attachment, refer to the initial commented section for the routing info used in that xn.
An application example for this is a good suggestion, and hopefully we can see one coming up in the shorter run.
regards,
/srinie