I have been looking into the xScope bidirectional endpoints but I can't seem to work out how to use it as a means to talk to 10 startKITs simultaneously. The startkits are being used to drive transducers and I need to send a 'Go' command from the computer to all the startkits at the same time in order to not mess up phases.
Can anyone help me with this? Thanks
Send data to 10 startKITs at the same time from computer Topic is solved
-
dsdanielko
- Active Member
- Posts: 33
- Joined: Sat Mar 12, 2016 3:12 pm
-
henkVerified
- Respected Member
- Posts: 347
- Joined: Wed Jan 27, 2016 5:21 pm
Hi dsdanielko,
xscope will go through a few non-real-time layers in your host; too maybe it is not ideal for this.
Could you connect the 10 start kits to a single wire, and get one of them to pull that up once to phase synchronise them? Put a pull down on it to keep it low during startup, you all do a timed input.
Cheers,
Henk
xscope will go through a few non-real-time layers in your host; too maybe it is not ideal for this.
Could you connect the 10 start kits to a single wire, and get one of them to pull that up once to phase synchronise them? Put a pull down on it to keep it low during startup, you all do a timed input.
Cheers,
Henk