Sound Card for XC-2
-
- Respected Member
- Posts: 363
- Joined: Thu Dec 10, 2009 10:17 pm
Well i could try to make a high quality version of the board, there is still some free room on it.
-
- XCore Legend
- Posts: 1274
- Joined: Thu Dec 10, 2009 10:20 pm
Just checking the expected port usage :
1 * 4 bit port for the both the I2C and Reset and MS/ADR
4 * 1 bit ports for the SPI ?
Is this correct?
regards
Al
1 * 4 bit port for the both the I2C and Reset and MS/ADR
4 * 1 bit ports for the SPI ?
Is this correct?
regards
Al
-
- Respected Member
- Posts: 363
- Joined: Thu Dec 10, 2009 10:17 pm
Yes that is correct. Id use 1bit ports on all of them but one connector only has 4.So i put I2C on a 4 bit port cause its not going to be used for other than setting up the card to a certain mode and only writes to the I2C are needed.
-
- Active Member
- Posts: 50
- Joined: Wed Dec 16, 2009 6:04 pm
- Location: London
i would go for ballanced XLR or TRS really ..
may be optical adat would be even easier? ..hm
i will try to figure something out as soon as i get my first kit!
digital i/o is better for me to use, so i can finally deploy the digital outputs and inputs of my soundcard!
may be optical adat would be even easier? ..hm
i will try to figure something out as soon as i get my first kit!
digital i/o is better for me to use, so i can finally deploy the digital outputs and inputs of my soundcard!
-
- Member++
- Posts: 17
- Joined: Thu Oct 14, 2010 12:07 am
did you ever print this board and try it?