I found the big connector on the XDK quite clumsy for experimenting and prototyping, so i quickly came up with a adapter board that changes the huge XDK header in to 4 smaller XC-1,2,3/XK-1 compatible headers, allowing the same hardware to be plugged in any of those kits.
The board is fit on to a single layer board so it is quite home etching friendly (Altho clearances are as low as 0.254mm so careful)
So i case anyone likes the idea here it is:
XDK I/O Adapter
-
Berni
- Respected Member
- Posts: 363
- Joined: Thu Dec 10, 2009 10:17 pm
XDK I/O Adapter
You do not have the required permissions to view the files attached to this post.
-
shawn
- XCore Addict
- Posts: 238
- Joined: Thu Dec 17, 2009 5:15 am
Nice hack, looks usefull for devlopment of course.