Hello
My question is actually very short and easy but I can't find the answer.
Can an output port on a XC-1A also provide a negative voltage?
I need to control a motor with my XC-1A, and I've found a circuit that can do that but it won't work if I can't get a negative signal. To make the motor rotate forward, I need to send a positive signal, to make it rotate backwads, it needs a negative signal.
Thanks,
Jasper Maes
Voltage output port
-
- Member
- Posts: 14
- Joined: Tue Oct 26, 2010 12:18 pm
-
- XCore Legend
- Posts: 1274
- Joined: Thu Dec 10, 2009 10:20 pm
No the chip itself cannot.
Normally you need to use a H-Bridge driver for a bidirectional motor
the XC1a signals can the be sent to control the bridge driver.
regards
Al
Normally you need to use a H-Bridge driver for a bidirectional motor
the XC1a signals can the be sent to control the bridge driver.
regards
Al
-
- Member
- Posts: 14
- Joined: Tue Oct 26, 2010 12:18 pm
Thanks.
I'll look into that.
I'll look into that.