Is it possible to use unused link pins in 2 wire mode? Topic is solved

If you have a simple question and just want an answer.
Redeye
XCore Addict
Posts: 131
Joined: Wed Aug 03, 2011 9:13 am

Is it possible to use unused link pins in 2 wire mode?

Post by Redeye »

I'm sure this is written somewhere but I can't seem to find it.If I use a link in 2 wire mode, can I still use the unused pins for that link as I/O? So on an L8-64 can I use port 4A while using XLA in 2-wire mode and port 4C while using XLB in 2-wire mode?I'm sure this is written somewhere but I can't seem to find it.If I use a link in 2 wire mode, can I still use the unused pins for that link as I/O? So on an L8-64 can I use port 4A while using XLA in 2-wire mode and port 4C while using XLB in 2-wire mode?


View Solution
Top
User avatar
Bianco
XCore Expert
Posts: 754
Joined: Thu Dec 10, 2009 6:56 pm

Post by Bianco »

When using a link in 2-wire mode, the pins that are used in 5-bit mode but not used in 2-bit mode are available to the corresponding I/O ports.
Top

Return to “Q&A”