is it possible to power the XCARD XC-1A by the 5V headers in the prototyping area? (bottom left in this image)
using an actual plug is just another possible point of failure in my project.
powering the XCARD XC-1A
-
- Experienced Member
- Posts: 75
- Joined: Thu Feb 02, 2012 3:32 pm
-
- XCore Expert
- Posts: 754
- Joined: Thu Dec 10, 2009 6:56 pm
I took a quick look at the schematics and this should be no issue.
The 5V of the headers are almost directly connected to the DC Jack (only a fuse inbetween).
The 5V of the headers are almost directly connected to the DC Jack (only a fuse inbetween).