Hello
i'm working with windows and linux using the dev kit:
"VocalFusion 4-mic mono-AEC circular dev kit" and "xtag3" programmer. I'm using the "vfk_spk_base" and the build "1i2o2_circ43_48khz" .
The dev kit uses the Cirrus Logic CS43L21 and now i will use the TLV320DAC3120 which is connected via i2s and i2c with the xmos.
How and/or where can i send configuration through i2c in the project "vfk_spk_base" to setup the amplifier?
Thanks in advance
twittich
how to configure amplifier with xmos Topic is solved
-
- Member++
- Posts: 16
- Joined: Mon May 06, 2019 9:28 am
-
- XCore Legend
- Posts: 1913
- Joined: Thu Jun 10, 2010 11:43 am
Hi. Review the attached document, appendix D - file is audiohw.xc
You do not have the required permissions to view the files attached to this post.
-
- Member++
- Posts: 16
- Joined: Mon May 06, 2019 9:28 am
Thank you I'll follow this. I didn't find that file before.
-
- Member++
- Posts: 16
- Joined: Mon May 06, 2019 9:28 am
Some more questions regarding the amplifier configuration.
The mentioned build ("vfk_spk_base" and the build "1i2o2_circ43_48khz") what is the codec interface word length and the lrclk and bclk and where can it be set ?
Thank you in advance.
twittich
The mentioned build ("vfk_spk_base" and the build "1i2o2_circ43_48khz") what is the codec interface word length and the lrclk and bclk and where can it be set ?
Thank you in advance.
twittich
-
- Member++
- Posts: 16
- Joined: Mon May 06, 2019 9:28 am
The clocks i have already but not where any setting can be changed, would be nice to know.
Word length 16 bit, lrclk 48 kHz, BCLK 3 MHz.
Word length 16 bit, lrclk 48 kHz, BCLK 3 MHz.