Are there any boards with external SRAM/SDRAM available ?

Non-technical related questions should go here.
ale500
Respected Member
Posts: 259
Joined: Thu Sep 16, 2010 9:15 am

Re: Are there any boards with external SRAM/SDRAM available ?

Postby ale500 » Thu Jan 06, 2011 6:57 pm

I want to do a... logic analyzer... a bench logic analyzer that does not depend on a PC (Like the one I have now Intronix, although good requires a PC). This is only the front-end. If it works as I want then I'll go for this design if not I'll have to change to an AVR32.... let's see :). This will rock !
User avatar
TonyD
XCore Addict
Posts: 234
Joined: Thu Dec 10, 2009 11:11 pm
Location: Newcastle, UK

Postby TonyD » Fri Jan 07, 2011 10:21 am

Ale, they look a nice set of boards.

A standalone logic analyser sounds like a great project. Keep us posted on your progress !
ale500
Respected Member
Posts: 259
Joined: Thu Sep 16, 2010 9:15 am

Postby ale500 » Sat Jan 08, 2011 9:06 am

I have the display working. A 480x272 TFT, I'm only using 6 bits for color... No need for 24 bit just right now.
You do not have the required permissions to view the files attached to this post.
User avatar
lilltroll
XCore Expert
Posts: 955
Joined: Fri Dec 11, 2009 3:53 am
Location: Sweden, Eskilstuna

Postby lilltroll » Sat Jan 08, 2011 12:52 pm

Is the green board one of the pieces in XSMB-L1 ??
Probably not the most confused programmer anymore on the XCORE forum.
ale500
Respected Member
Posts: 259
Joined: Thu Sep 16, 2010 9:15 am

Postby ale500 » Sat Jan 08, 2011 2:44 pm

The green board is the LCD breakout from Rayslogic. The XS1 MBs should come in 2 weeks :)
ale500
Respected Member
Posts: 259
Joined: Thu Sep 16, 2010 9:15 am

Postby ale500 » Fri Jan 21, 2011 6:16 pm

The boards arrived !... now I have to cut them :) and populate them
You do not have the required permissions to view the files attached to this post.
User avatar
Folknology
XCore Legend
Posts: 1274
Joined: Thu Dec 10, 2009 10:20 pm

Postby Folknology » Fri Jan 21, 2011 8:19 pm

Nice, hope you have a steady hand to solder them up;-)
ale500
Respected Member
Posts: 259
Joined: Thu Sep 16, 2010 9:15 am

Postby ale500 » Fri Jan 21, 2011 9:55 pm

Cutting the boards is proving challenging enough due to the short distance between them...
User avatar
Berni
Respected Member
Posts: 363
Joined: Thu Dec 10, 2009 10:17 pm

Postby Berni » Fri Jan 21, 2011 11:57 pm

Looking nice there, good luck on getting the boards to work quickly.
ale500
Respected Member
Posts: 259
Joined: Thu Sep 16, 2010 9:15 am

Postby ale500 » Mon Jan 24, 2011 8:37 pm

Small update,

the 1 V switching regulator works well. Now for the reset circuit. (I do not find the 100 nF 0603 that I have... so I have to keep searching...)

Who is online

Users browsing this forum: No registered users and 0 guests