So the XS1-L1 footprint is supposed to be in the opencircuits/sparkfun library, but it is not there. I tried looking through it in the library editor, downloading the old version that said that was new, but I can't find it!
If this just me? Could someone pull it out of the sparkfun library and attach it?
Can't find XS1-L1 in the eagle library
-
rp181
- Respected Member
- Posts: 395
- Joined: Tue May 18, 2010 12:25 am
-
ale500
- Respected Member
- Posts: 259
- Joined: Thu Sep 16, 2010 9:15 am
Here is my version. L1 tqfp 64 & 128
You do not have the required permissions to view the files attached to this post.
-
rp181
- Respected Member
- Posts: 395
- Joined: Tue May 18, 2010 12:25 am
Thank you so much!
Is this package verified?
Is this package verified?
-
ale500
- Respected Member
- Posts: 259
- Joined: Thu Sep 16, 2010 9:15 am
I used the latest version of the datasheet. You of course can verify it again :) and then we are sure that it is ok.
-
russf
- XCore Addict
- Posts: 146
- Joined: Thu Dec 10, 2009 10:17 pm
It's great that you have shared these files.
Could you also put them, once verified, on the Cadsoft site, to attract more users?
It would be beneficial if XMOS did this for the whole range of devices.
Eagle is getting a lot of attention, and microchip and others seem to keep more or less up to date with many key parts.
Could you also put them, once verified, on the Cadsoft site, to attract more users?
It would be beneficial if XMOS did this for the whole range of devices.
Eagle is getting a lot of attention, and microchip and others seem to keep more or less up to date with many key parts.
-
rp181
- Respected Member
- Posts: 395
- Joined: Tue May 18, 2010 12:25 am
I have soldered a chip of the 64LQFP part, it works fine!
-
octal
- XCore Addict
- Posts: 228
- Joined: Thu Jan 27, 2011 3:30 pm
- Location: Argenteuil - France
Anyone tested (validated) the 128pin pinout?
-
ale500
- Respected Member
- Posts: 259
- Joined: Thu Sep 16, 2010 9:15 am
I used it in my L1 Stamp board... I haven't finished soldering it yet (I lost the bag with the 100 nF 0603 capacitors I had when I moved :/, so I'm ordering new ones... A few days and I'll be able to test it :). You are free to check it against the datasheet (use the latest version as aerlier ones had errors).