I found the big connector on the XDK quite clumsy for experimenting and prototyping, so i quickly came up with a adapter board that changes the huge XDK header in to 4 smaller XC-1,2,3/XK-1 compatible headers, allowing the same hardware to be plugged in any of those kits.
The board is fit on to a single layer board so it is quite home etching friendly (Altho clearances are as low as 0.254mm so careful)
So i case anyone likes the idea here it is:
XDK I/O Adapter
XDK I/O Adapter
- Attachments
-
- etch mask 1.pdf
- (25.21 KiB) Downloaded 185 times
- etch mask 1.pdf
- (25.21 KiB) Downloaded 185 times
Nice hack, looks usefull for devlopment of course.