When I try to run the compiled application I get an error message about xgdb.exe having a problem and needing to close.The same thing happens if I create a debug configuration.
I'm using XDE 9.9.1.
Leon
Problem running xmos_tcpip_1V0 on XC-2
-
- XCore Expert
- Posts: 546
- Joined: Thu Dec 10, 2009 10:41 pm
- Location: St. Leonards-on-Sea, E. Sussex, UK.
-
- XCore Addict
- Posts: 207
- Joined: Thu Dec 10, 2009 11:00 pm
- Location: Mexico
from where you have downloaded xmos_tcpip_1V0 on XC-2?
I just discovered that I use old stack.
I just discovered that I use old stack.
-
- XCore Legend
- Posts: 1274
- Joined: Thu Dec 10, 2009 10:20 pm
Ok I built it running XDE on Ubuntu without any probs and targeted my XC-2 which it then ran on to give me 'hello world'.
Maybe obvious but have you tried the following:
Have you setup the IP address in demo/main.xc with the appropriate netmask/gateway?
Have you tried building the ethernet demo to see if that works with the same IP setting?
regards
Al
Maybe obvious but have you tried the following:
Have you setup the IP address in demo/main.xc with the appropriate netmask/gateway?
Have you tried building the ethernet demo to see if that works with the same IP setting?
regards
Al
-
- Respected Member
- Posts: 377
- Joined: Thu Dec 10, 2009 6:07 pm
I think it's here:otitov wrote:from where you have downloaded xmos_tcpip_1V0 on XC-2?
I just discovered that I use old stack.
https://www.xmos.com/products/developme ... hernet-kit
-
- XCore Legend
- Posts: 1274
- Joined: Thu Dec 10, 2009 10:20 pm
And the other obvious one setting the target to XC-2.
-
- XCore Addict
- Posts: 207
- Joined: Thu Dec 10, 2009 11:00 pm
- Location: Mexico
@Jonathan: thanks!