Hi guys!
Is there any examples like the above for XCORE 200 Explorer kit. Particularly ADC and PID controller.
I know there is one for ADC "interfacing ADCs with xcore" but would appreciate if i can use PID or PI in the control loop .
is there way to move forward in doing this on Xcore explorer kit ?
Thank you
How to use the ADC on StartKit?
-
Schatz143
- Member++
- Posts: 31
- Joined: Mon Jan 20, 2020 9:54 am
-
mon2
- XCore Legend
- Posts: 1913
- Joined: Thu Jun 10, 2010 11:43 am
Hi. See if the attached helps.
Review the StartKit supplied examples and change the port pins relevant to the new Explorer Kit to run on the new target. That is, start with a blank template on the IDE -> target the Explorer Kit (XMOS tools will auto-fill in the Explorer Kit specifics -> then open up / import any of the StartKit examples -> cut & paste the source code from the StartKit but into your Explorer Kit project -> change the ports to suit and compile and test.
https://www.xmos.com/file/an01021-inter ... with-xcore
https://www.xcore.com/viewtopic.php?t=524&start=20
https://www.element14.com/community/com ... obot-xmp-2
Review the StartKit supplied examples and change the port pins relevant to the new Explorer Kit to run on the new target. That is, start with a blank template on the IDE -> target the Explorer Kit (XMOS tools will auto-fill in the Explorer Kit specifics -> then open up / import any of the StartKit examples -> cut & paste the source code from the StartKit but into your Explorer Kit project -> change the ports to suit and compile and test.
https://www.xmos.com/file/an01021-inter ... with-xcore
https://www.xcore.com/viewtopic.php?t=524&start=20
https://www.element14.com/community/com ... obot-xmp-2
You do not have the required permissions to view the files attached to this post.