Excuse the slightly dumb question but if I burn a MAC address into a device using :
xburn -mac-address mac
can I put a serial number/code etc in at a later date by using xburn again, or does everything I want to do need to be done in a single xburn command?
XBURN question
-
- XCore Addict
- Posts: 131
- Joined: Wed Aug 03, 2011 9:13 am
-
- XCore Legend
- Posts: 1126
- Joined: Thu May 27, 2010 10:08 am
The general advice is is to write everything you need to program in a single xburn command.
You may find that on the bench you can get away with programming individual locations at different times, especially if small writes. This is due to the redundancy mechanisms included which are included to improve yield. It is certainly not something you should ever do in a production environment.
The actual programming mechanism and format is more complex than a bitmap of fuses to be blown (it includes headers etc.). Ultimately, the storage mechanism is a fuse (which cannot be unblown), so to be safe, writing your image to OTP in one hit is the recommended usage.
You may find that on the bench you can get away with programming individual locations at different times, especially if small writes. This is due to the redundancy mechanisms included which are included to improve yield. It is certainly not something you should ever do in a production environment.
The actual programming mechanism and format is more complex than a bitmap of fuses to be blown (it includes headers etc.). Ultimately, the storage mechanism is a fuse (which cannot be unblown), so to be safe, writing your image to OTP in one hit is the recommended usage.
-
- XCore Addict
- Posts: 131
- Joined: Wed Aug 03, 2011 9:13 am
Thanks, that's what I suspected.
In searching for an answer to this question I did find a thread which referred to an xburn bug which stopped you locking the device at the same time as doing other things. Is this fixed now?
In searching for an answer to this question I did find a thread which referred to an xburn bug which stopped you locking the device at the same time as doing other things. Is this fixed now?
-
- XCore Legend
- Posts: 1126
- Joined: Thu May 27, 2010 10:08 am
Yes - that bug was fixed in 12.1 so the latest tools version (12.2) doesn't exhibit that problem :)