How can I make chain connector for my custom usb slice kit f

[jigneshprajapati]

I am making my own custom USB Slice Kit board from schematic of standard USB slice kit.In my custom board I want to make chain connector to connect same custom usb board via square slot.In standard USB slice kit chain connector is not available.So I want to know that how to assign or connect pins of chain connector to xmos processor ?The Pins of chain connector are clk, debug, msel, prsnt, rst, tck, gnd, tdo, X0D21, X0D20, X0D13, X0D19, X0D18, tms, tDi, XoD15 , X0D14, X0D22, X0D17, X0D16.FYI Chain connector is PCIe 36 pin connector as per standard Slice Kit.

[sethu_jangala]

If you wan to chain the USB sliceKITs, you need to change the standard IDC header (header used to connect to xTAG 2 adapter) to PCIe connector as in the general purpose sliceKIT. The following signals need to come out of the connector:DEBUG_N, TCK, TDO, PRSNT_MSTR_PIN, CLK_IN, MSEL, TMS, TDI, RST_N_IN.Have a look at he general purpose sliceKIT schematics for more details:https://www.xmos.com/support/xkits/?sub ... duct=15825