Version: 0.1
Status: Under development
License: Custom Licence
Download: http://solderpad.com/folknology/slice-cobbler/
Slice boards are to small to adequately place breadboards because of their width restrictions (They have to be neighbourly), however you can cobble your pins from the Slicekit to your breadboard providing breakout using some headers, IDC cable and this. This board provides the breakout end of the cobbler that goes into the breadboard. you can use the onboard test headers (I recommend square) by populating them with an IDC male shrouded header. the IDC cable then links the two together. Don't forget you will also need to run power and ground to the breadboard either by populating the power headers on the slice kit or via a supply with linked ground.
Images:
Slice Cobbler
-
- XCore Legend
- Posts: 1274
- Joined: Thu Dec 10, 2009 10:20 pm