I just received an XK-USB-MIC-UF216. I have a separate thread about flashing (https://www.xcore.com/viewtopic.php?f=8&t=6827).
I was able to get my compiled program to run using
However, now I have another problem: microphone 0 is just a ton of noise. Mics 1-6 work properly. Channel 7 is just a DC offset, which I assume is fine since there is no actual microphone on that channel.
Code: Select all
I attached a screenshot of a recording from the microphones. Is this a hardware PCB problem, or is it possible that it's a software problem?
You can see in the image that mic0 is noise. I rub each microphone from 0 to 6 in order, and you can see each mic respond accordingly. Thanks,