xrun: Cannot load image, XCore 0 is not enabled
-
- Experienced Member
- Posts: 78
- Joined: Thu Mar 08, 2018 2:44 pm
I am using usb in and 2 spdif ins. And while i can power it with USB i am using just 2 poles and an external power supply for the 5V
-
- Experienced Member
- Posts: 78
- Joined: Thu Mar 08, 2018 2:44 pm
New fresh error - Error on tile[0]: failed to connect to flash device. Please verify that SQI type is supported and that the correct SQI ports are defined within your xn file. Looking into it i did find similar posts and I am using the default codes, but I don't know how to proceed with adapting to my situation.
xflash: Error: F03096 Node "0" is configured to boot from a device but no suitable device was found.
This posts when i try flashing a new Hello world onto it
xflash: Error: F03096 Node "0" is configured to boot from a device but no suitable device was found.
This posts when i try flashing a new Hello world onto it
-
- XCore Legend
- Posts: 1913
- Joined: Thu Jun 10, 2010 11:43 am
Post full part number and vendor of the flash being used.
-
- Experienced Member
- Posts: 78
- Joined: Thu Mar 08, 2018 2:44 pm
SST26VF016-80-5I-S2AE FLASH MEMORY, 16MBIT, 80MHZ, SOIC-8 85423275 Manufacturer code - SST26VF016-80-5I-S2AE -- -Bought from Farnell
-
- Experienced Member
- Posts: 78
- Joined: Thu Mar 08, 2018 2:44 pm
I used an osciloscope to monitor what happens to the pins during flash and a spike is always present when it tries to flash so connection is out of the way i guesss