Hi all,
I have been trying to read the device firmware that comes pre-installed on the Xcore-200 MC Audio board using the XTAG3 programmer.
From what I understand using xflash enables you to read the binary file with a command like
"xflash --read-all -o device_firmare_dump.bin --target XE216-512-TQ128-C20"
this outputs
Warning: XN11135 Attribute SystemFrequency is ignored when Oscillator is not specified.
Warning: XN11206 Oscillator is not specified for USB node.
Error: F03040 Platform definition (XN) does not specify a boot flash device.
which makes sense, so I tried using the target-file option which I presumed is the .xn file, i tried the .xn file that comes with the example firmware
xflash --read-all -o out.bin --target-file xk-audio-216-mc.xn
this outputs
Error: Failed to recognise flash device at node "0".
xrun: Program received signal ET_LOAD_STORE, Memory access exception.
0x000408cc in fl_getPageSize ()
Error: F03013 Failed to run : 008FEA48.
has anyone tried reading the firmware?
thanks in advance!
read device firmware
-
- New User
- Posts: 2
- Joined: Fri Feb 01, 2019 11:11 pm
-
- XCore Legend
- Posts: 1913
- Joined: Thu Jun 10, 2010 11:43 am
Can you repeat your attempt but add --verbose to the command line and post your output?