boot from xlink Topic is solved

[etori90]

Hi , I need help for booting Xcore 200 board from other Xcore 200 board
There is no problem running two boards at xTimecomposer.
but when i try flashing, Console shows it was flahsed successfully but nothing happens.

I connected two boards by Xlink 0 ( xsys connector) and 3.9k pull up resistor is strapped onto the X0D06 Pin of Slave board.

This is console message

xflash: Warning: F03148 --quad-spi-clock not given, using default 15.62MHz

Site 0 has started.
Site 0 write 0x00003c00.
Site 0 verified 0x00003c00.
Site 0 write 0x00007800.
Site 0 verified 0x00007800.
Site 0 has finished successfully.

and I attached Xn file

[CousinItt]

I don't see why it shouldn't work.

Can you provide more information about how you are linking the boards? Signal integrity is crucial. Assuming you are wiring the boards together the links should be short and there have to be plenty of short ground links between the boards.

Take a look here too: link.

[etori90]

Thank you!
I referred to that link.
The difference is that I connected XL0 between two boards, not to XTAG.
As i know XL0 is related with xscope not flashing , is this right?
should i connect XL0 to XTAG ?

[etori90]

I solved
It was reset problem
reset releasing timing after flashing should be synchronized