xmap: Error: Type sig for port or clock is missing.

[RitchRock]

Hi Everyone,

Updating some code and when I go to clean and build my updates (previously compiled fine) I am getting the following error:

xmap: Error: Type sig for port or clock is missing.

I can't seem to figure out why - I didn't change any ports or clocks or anything related to my setup on the XU216 and can't seem to find this error searching on xcore.com.

Any suggestions on what this would be related to would be helpful.

[RitchRock]

I tried starting fresh from a known good state, but when I bring my changes in I still get this issue. There is no further information given by xTimeComposer, so I don't know where to look. Using tools 14.4.1

[CousinItt]

Can you revert to your previous revision and check it then builds correctly again? Not sure if that was what you meant.

[RitchRock]

Yes that’s what I meant. Previous version is fine.