using an actual plug is just another possible point of failure in my project.
powering the XCARD XC-1A
-
Gravis
- Experienced Member
- Posts: 75
- Joined: Thu Feb 02, 2012 3:32 pm
powering the XCARD XC-1A
is it possible to power the XCARD XC-1A by the 5V headers in the prototyping area? (bottom left in this image)
using an actual plug is just another possible point of failure in my project.
using an actual plug is just another possible point of failure in my project.
-
Bianco
- XCore Expert
- Posts: 754
- Joined: Thu Dec 10, 2009 6:56 pm
I took a quick look at the schematics and this should be no issue.
The 5V of the headers are almost directly connected to the DC Jack (only a fuse inbetween).
The 5V of the headers are almost directly connected to the DC Jack (only a fuse inbetween).