XScope on port other than Tile 0, XL0 Topic is solved

Technical discussions around xCORE processors (e.g. General Purpose (L/G), xCORE-USB, xCORE-Analog, xCORE-XA).
gcore
Member
Posts: 11
Joined: Thu Oct 06, 2016 4:58 am

XScope on port other than Tile 0, XL0

Postby gcore » Tue Dec 06, 2016 12:55 am

I have a hardware design that routes the XLink connections from the 20 pin xTag3 debug header to a XU216-256-TQ128-C20 device's XL3 port on tile 1. I'm working with the default XN file for the XU216-256-TQ128-C20 device, copied into the xTIMEcomposer project from C:\Program Files (x86)\XMOS\xTIMEcomposer\Community_14.2.1\targets\XU216-256-TQ128-C20. I'm trying to add in a section to the XN file that will configure XL3 as the XScope connection.

I have no trouble doing this with a board that has the XLink connected to XL0 on tile 0, using the following lines:

Code: Select all

  <Nodes>
    <Node Id="2" Type="device:" RoutingId="0x8000">
      <Service Id="0" Proto="xscope_host_data(chanend c);">
        <Chanend Identifier="c" end="3"/>
      </Service>
    </Node>
  </Nodes>
  <Links>
    <Link Encoding="2wire" Delays="4,4" Flags="XSCOPE">
      <LinkEndpoint NodeId="0" Link="XL0"/>
      <LinkEndpoint NodeId="2" Chanend="1"/>
    </Link>
  </Links>
Could anyone point me in the right direction for coaxing this to work for XL3 on tile 1?

Any suggestions welcome.

Cheers!
View Solution
Redeye
Experienced Member
Posts: 109
Joined: Wed Aug 03, 2011 9:13 am

Postby Redeye » Tue Dec 06, 2016 7:43 am

It should be as simple as changing the line :

Code: Select all

<LinkEndpoint NodeId="0" Link="XL0"/>
to :

Code: Select all

<LinkEndpoint NodeId="0" Link="XL3"/>
gcore
Member
Posts: 11
Joined: Thu Oct 06, 2016 4:58 am

Postby gcore » Wed Dec 14, 2016 4:15 am

Thanks Redeye, that is indeed all that is required. I had tried that already, but was being misled due to needing to also power the xtag device off and back on before the change takes effect.

Who is online

Users browsing this forum: No registered users and 0 guests