XCORE-200, How to set the IO port to sample data at the same time as the rising edge and the falling edge of the clock?
thx
about: XCORE-200, IO, the rising edge and the falling edge
-
- Active Member
- Posts: 37
- Joined: Wed Jan 09, 2019 10:57 am
-
- XCore Expert
- Posts: 580
- Joined: Thu Nov 26, 2015 11:47 pm
It sounds like you want to sample a pin on both falling and rising edge of the clock. I don't think that's possible with XCORE-200. If you could supply more information about your application someone clever might come up with a solution.
-
- Active Member
- Posts: 37
- Joined: Wed Jan 09, 2019 10:57 am
For example:akp wrote:It sounds like you want to sample a pin on both falling and rising edge of the clock. I don't think that's possible with XCORE-200. If you could supply more information about your application someone clever might come up with a solution.
PDM microphone, a 1bit port connected with 2dmic, They are left and right vocal tracts, respectively.
In order to obtain two microphone signals, both rising and falling edges need to be sampled simultaneously.
In addition, If XCORE-200 can't, which type of chip is OK?
thx