Exist any document about xburn repeat use process in developer mode.
I make some tests and isnt clean how code and changes is enabled...
Xburn explained documents
-
mmar
- XCore Addict
- Posts: 131
- Joined: Fri Jul 05, 2013 5:55 pm
-
fabriceo
- XCore Addict
- Posts: 222
- Joined: Mon Jan 08, 2018 4:14 pm
Hi mmar,
you probably have seen this page :
https://www.xmos.com/documentation/XM-0 ... anual.html
also there is a chapter 5.1.7 in the latest guide_tool pdf document
https://www.xmos.com/documentation/XM-0 ... _v15.2.pdf
hope this helps
you probably have seen this page :
https://www.xmos.com/documentation/XM-0 ... anual.html
also there is a chapter 5.1.7 in the latest guide_tool pdf document
https://www.xmos.com/documentation/XM-0 ... _v15.2.pdf
hope this helps
-
mmar
- XCore Addict
- Posts: 131
- Joined: Fri Jul 05, 2013 5:55 pm
Thanks for links, but this is all basic info. Never writed about enable disable and back enable or multiple use write otp file usw.
-
markpVerified
- Member
- Posts: 10
- Joined: Thu Jan 10, 2019 6:07 pm
Could you explain in more detail the steps you would like to carry out?
And the device you are using - XCORE-200 family (XU216...) or xcore.ai (XU316...)
And then we can figure which xburn commands should be used (and update the XMOS documentation)?
Bear in mind for some uses, all options must be supplied at the the same time with one invocation of the xburn command.
And the device you are using - XCORE-200 family (XU216...) or xcore.ai (XU316...)
And then we can figure which xburn commands should be used (and update the XMOS documentation)?
Bear in mind for some uses, all options must be supplied at the the same time with one invocation of the xburn command.