Hi all,
What is the recommended way to run the XMOS spi master component
on a different tile than tile 0? (I am using a XC-1A dev kit).
Is is just to edit the xn.file and to move the involved port defs to a
different tile ?
Otherwise short example how to configure this would be great.
Thanks in advance.
XMOS xSOFTip SPI master component
-
- Active Member
- Posts: 62
- Joined: Sat Sep 17, 2011 12:05 pm
-
- XCore Expert
- Posts: 589
- Joined: Wed Feb 29, 2012 10:03 am
Hello,
If you need to run run SPI component on other tile you can run using SPI xSOFTip component. You just need to change the tile ID to the tile on which you want to run the example and declare the ports on the tile you want to run. If you are talking about changing the SPI boot flash to other tile, this is not supported by the tools.
Sethu.
If you need to run run SPI component on other tile you can run using SPI xSOFTip component. You just need to change the tile ID to the tile on which you want to run the example and declare the ports on the tile you want to run. If you are talking about changing the SPI boot flash to other tile, this is not supported by the tools.
Sethu.