Hi all,
unfortunately I could not find any documentation about how many instructions can be executed in the events, such as EVT_SYS_INIT = [] or EVT_USB_CONNECT = [], ...
Is there an upper limit? I tried to fix my problems (https://www.xcore.com/forum/viewtopic.p ... 268#p23268) with a temporary workaround, but sometimes the XHRA-2HPA does not make anything, also the image on the flash (created by the xConfigurator) is verified. Maybe this behavior indicates, that the number of executions is exceeded?!
Thank you!
XHRA-2HPA number of max. intructions in events
-
- Junior Member
- Posts: 6
- Joined: Fri Apr 15, 2016 3:32 pm
-
- XCore Expert
- Posts: 968
- Joined: Thu Dec 10, 2009 9:20 pm
- Location: Bristol, UK
Valid question. In general USB requests should be dealt with < 1 second (sample rate change etc) The init and connect events are likely to be more sensitive. I will have to look into this.
-
- Respected Member
- Posts: 347
- Joined: Wed Jan 27, 2016 5:21 pm
I am not sure if this helps, but XHRA cannot support more than 2048 bytes in its configuration flash.
Cheers,
Henk
Cheers,
Henk
-
- Junior Member
- Posts: 6
- Joined: Fri Apr 15, 2016 3:32 pm
Thank you Henk. Good to know.
In this case my workaround is unconvertible, anyway.
But I wonder, that I could create a configuration with more than 2048 bytes and there was neither an error nor a warning?!
In this case my workaround is unconvertible, anyway.
But I wonder, that I could create a configuration with more than 2048 bytes and there was neither an error nor a warning?!