Can anybody please advise on the different options available to populate the I/O expansion areas on the development kit? I'd prefer a method that allows me to conveniently connect to specific pins as I develop... Is it best to bridge these over a breadboard where I can connect other breakout boards or sensors? If not, what's best?The I/O pins of XCore1, XCore2 and XCore3 are brought out to expansion areas on
both sides of the card. These areas have 0.1” pitch plated through holes and are
suitable for use with IDC headers. To provide maximum flexibility, no headers are
fitted, allowing the most suitable type to be selected.
My search only results in headers such as the one below. I can find plugs for this header but they tend to go out to a ribbon cable, which I am not sure will be ideal for using to access pins in development.
Any help would be great :).
Dan.